1. Introduction
The development of sustainable platforms for biodegradable cellular scaffolds requires the engineering of functional materials coupling versatile physicochemical properties, biocompatibility, and tunable stability in biofluids. A well-investigated material to this end is nanostructured ZnO [
1]. ZnO nanostructure (n-ZnO) geometry influences both stability and functionality. For instance, ZnO nanoparticles are toxic toward different kinds of cell lines [
2], due to a fast (<1 h) dissolution process. On the contrary, 1D n-ZnO is biocompatible, as reported by the Food and Drug Administration (21CFR182.8991) [
3]. Nevertheless, the dissolution of n-ZnO occurs with kinetics of the order of some hours [
4]. This can modify zinc homeostasis and lead to reactive oxygen species, which can trigger apoptosis [
5]. In this scenario, there is still a lack in knowledge of n-ZnO stability when used as is or as filler within biocompatible matrixes. To fill this knowledge gap, this preliminary study leverages electrochemical detection methods based on electrical impedance and voltammetry to provide a first glance of the stability of n-ZnO in aqueous solutions.
2. Materials and Methods
n-ZnO growth is achieved in a 250 mL solution in ultrapure DI water with resistivity at 25 °C > 18.2 MΩ·cm (Direct-Q® 3 UV Water Purification Systems, Merck Millipore, Burlington, MA, USA). The solution contains 15 mM zinc nitrate hexahydrate (Sigma Aldrich, St. Louis, MO, USA, ≥99.0%), 7.5 mM hexamethylenetetramine (Sigma Aldrich, ≥99.0%), 0.10 M ammonia (Alfa Aesar, Haverhill, MA, USA, 28% v/v in water), 2 mM polyethylenimine (Sigma Aldrich, average Mw ≈ 800, average Mn ≈ 600), 5 mM potassium chloride (Fluka, Charlotte, NC, USA, >99.0%), and 15 mM monoethanolamine (Sigma Aldrich, ≥99.0%). The precipitates at the bottom of the container are collected, washed with DI water, dried at 60 °C for 24 h, and calcined at 200 °C for 2 h. Electrochemical measurements are carried out using Autolab PGSTAT128N (Metrohm AG, Herisau, Switzerland).
3. Discussion
The synthesized n-ZnO is analyzed by spectroscopic (UV-visible) and electrochemical (cyclovoltammetry) methods. Preliminary impedance measurements are conducted on n-ZnO (at 0.2 mg/mL concentration) dispersion in ultrapure water using two identical graphite electrodes soaked in the analysis solution. The solution impedance is measured from 5 min to 20 min and finally after 3 days. The resulting decrease in the electrical impedance is quantified by the reduction in the diameter observed in the Nyquist plot (
Figure 1a), which shows the negative value of the imaginary versus the real parts of the complex impedance. Ongoing experiments aim at the voltammetric determination of zinc ions using Britton–Robinson buffer (pH 7.0) as the background electrolyte [
6]. To this end, anodic stripping detection of zinc on a disposable screen-printed gold electrode shows the zinc ion release from the n-ZnO at ppm levels (
Figure 1b). Whereas in principle, zinc ions in biofluids could pose a challenge for living cells, this preliminary study shows that the released zinc ions are at concentrations below the limits that would cause dyshomeostasis. Ongoing studies are looking at the preparation of n-ZnO–cellulose composites for minimizing such zinc ion leakage into solution.
Author Contributions
Conceptualization, G.A. and B.P.; methodology, V.F. and G.P.; investigation, G.P., P.G.M. and M.S.; resources, G.A. and B.P.; writing—original draft preparation, G.A.; writing—review and editing, V.F., B.P. and P.G.M.; funding acquisition, G.A. and B.P. All authors have read and agreed to the published version of the manuscript.
Funding
This research was funded by the European Union—NextGenerationEU—fondi MUR D.M. 737/2021—research project Zoomer, CUP B79J21038330001. This study was also developed in the framework of the research activities carried out within the Project “Network 4 Energy Sustainable Transition—NEST”, Spoke 1, Project code PE0000021, funded under the National Recovery and Resilience Plan (NRRP), Mission 4, Component 2, Investment 1.3 — Call for tender No. 1561 of 11.10.2022 of Ministero dell’Università e della Ricerca (MUR); funded by the European Union—NextGenerationEU.
Institutional Review Board Statement
Not applicable.
Informed Consent Statement
Not applicable.
Data Availability Statement
The data presented in this study are available on request from the corresponding author.
Conflicts of Interest
The authors declare no conflict of interest.
References
- Arrabito, G.; Errico, V.; Zhang, Z.; Han, W.; Falconi, C. Nanotransducers on printed circuit boards by rational design of high-density, long, thin and untapered ZnO nanowires. Nano Energy 2018, 46, 54–62. [Google Scholar] [CrossRef]
- Errico, V.; Arrabito, G.; Fornetti, E.; Fuoco, C.; Testa, S.; Saggio, G.; Rufini, S.; Cannata, S.; Desideri, A.; Falconi, C.; et al. High-Density ZnO Nanowires as a Reversible Myogenic–Differentiation Switch. ACS Appl. Mater. Interfaces 2018, 10, 14097–14107. [Google Scholar] [CrossRef] [PubMed]
- Bhat, S.S.; Qurashi, A.; Khanday, F.A. ZnO nanostructures based biosensors for cancer and infectious disease applications: Perspectives, prospects and promises. TrAC 2017, 86, 1–13. [Google Scholar] [CrossRef]
- Zhou, J.; Xu, N.S.; Wang, Z.L. Dissolving behavior and stability of ZnO wires in biofluids: A study on biodegradability and biocompatibility of ZnO nanostructures. Adv. Mater. 2006, 18, 2432–2435. [Google Scholar] [CrossRef]
- Ostrovsky, S.; Kazimirsky, G.; Gedanken, A.; Brodie, C. Selective cytotoxic effect of ZnO nanoparticles on glioma cells. Nano Res. 2009, 2, 882–890. [Google Scholar] [CrossRef]
- da Silva, S.M.; Squissato, A.L.; Rocha, D.P.; Vasconcellos, M.L.; de QFerreira, R.; Richter, E.M.; Munoz, R.A. Improved anodic stripping voltammetric detection of zinc on a disposable screen-printed gold electrode. Ionics 2020, 26, 2611–2621. [Google Scholar] [CrossRef]
| Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2024 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).